|
FIRST FLOOR - the below windows and door are from Eastern aspect, then North, then West and finally Southern aspect Caution: Depending on your monitor and your printer the sketches in the above 2 URL may not be reflective, however the dimensions listed therein are reliable. Hence, you can also click on: Paper based sketches of all windows and doors on First Floor
9 items comprising:
1 louvre shutter window (Living room) FIRST FLOOR FACING EAST Southern side above existing concrete balcony Double sliding door which should be same width as existing double garage door opening beneath it 2500mm wide x 2200mm high FIRST FLOOR FACING EAST Northern side above existing concrete balcony Shutter on Southern end with fixed panel window with as few as possible vertical separations and a louvre window. Window should run from the vertical steel column/post in NE corner down to existing end of cavity for existing window. The drawing shows a 1,000mm wide window at NE end. However, merit exists in any vertical window supports being at southern end and not northern end to minimise interruption of the view. The below sketch is counted as 2 windows 3750mm wide x 1530mm high
FIRST FLOOR FACING NORTH NE corner
Fixed panel window with as few as possible vertical separations. From cavity which should be same height
as above window which will be on the Eastern wall. FIRST FLOOR FACING NORTH Bedroom #2 Replace existing double sliding window 1860mm wide x 1500mm high FIRST FLOOR FACING WEST Bedroom #1 Replace existing double sliding window 1860mm wide x 1500mm high FIRST FLOOR FACING WEST Bathroom Replace existing double sliding window - new sliding window can be higher than existing 480mm window provided it is cost effective to cut out some existing brick works 1390mm wide x 450mm high FIRST FLOOR FACING WEST Study Replace existing double sliding window with double sliding doors - not altering the existing cavity width 1860mm wide x 2150mm high FIRST FLOOR FACING SOUTH Kitchen Replace existing sliding window with new double sliding window the same dimensions - not altering the existing cavity 1650mm wide x 980mm high |
|
|